Sink Stopper Won T Seal

It moves the stopper in the opposite direction to the lift rod.

Sink stopper won t seal. The gasket located under the stopper may also need to be adjusted. The ball rod is inserted into the side of the drain and attached with a nut. Unthread the sink stopper s tailpipe from the underside of the drain. Re tighten the thumb screw by turning clockwise.

Click here for maintenance and service parts. A sink stopper mechanism isn t difficult to understand. Gasket to push outward. The photo on the left fig.

Water may leak or refuse to drain around a sink pop up for a number of reasons. Find replacement parts on amazon. The lever hooks onto the stopper through a hole or hook on the bottom of a long plastic flange that s attached to the stopper. When you push or pull on the lift rod it activates a lever the extends through the drain tailpiece.

Peek above the sink to make sure the stopper is fully closed and that the pop up rod is pushed all the way down 3. Simply remove the plunger clean and if necessary replace. How to fix a sink pop up drain stopper. To reach the stopper the ball rod needs to be removed first.

The photo on the right fig. But sink stoppers fail. If your sink pop up won t pop up or seat properly fixing it is quite easy usually just a matter of adjusting a few parts. Remove stopper from drain.

A sink stopper with a push pull rod control at the faucet is a great modern convenience. 5 shows the gasket pushed out of position. If water still does not hold in the sink the next check will be the actual stopper seal. The ball rod holds the stopper in the drain.

Now that the bottom of the tailpipe if free from the p trap loosen the nut that connects it to the threaded bottom of the sink drain. Fix a sink stopper. A pivot rod that connects to the back of the drain pipe a perforated strap a clevis and a screw that locks the strap onto the stopper rod. This is a repair you can do yourself.

If a sink won t hold water look up behind the sink with a flashlight if needed to identify the following parts. The culprit is often a buildup of hair around the base of the stopper or the pivot rod mechanism. 6 shows the gasket seated correctly between the clicker assembly and the stopper. Remove clip from ball rod.

To remove unthread the rod nut pull the ball rod out and remove the stopper from the drain. The clicker may have been over tightened causing the.